1A 18650 LITHIUM BATTERY CHARGING BOARD WITH PROTECTION
₹25.00
You save
- TP4056 Battery Charging Module with Battery Protection
- Overcharge Protection, Overdischarge protection
- Current Limitation on Output pins
- Micro USB Input
- Input Voltage: 5V to 5.5V
- Battery Charge : 4.2V @ 1000mA
Frequently Bought Together
- This item: 1A 18650 LITHIUM BATTERY CHARGING BOARD WITH PROTECTION(
₹25.00
You save ) - 1X 18650 BATTERY HOLDER WITH WIRE(
₹20.00
You save ) - 2500mAh 18650 LI-ION RECHARGEABLE BATTERY(
₹99.00
You save ) - ANDROID MICRO USB CHARGING CABLE(
₹25.00
You save )
This TP4056 1A Li-Ion Battery Charging Board(Lipo charger) Micro USB with Current Protection is a tiny module, perfect for charging single cell 3.7V 1 Ah or higher lithium-ion (Li-Ion) cells such as 16550s that don’t have their own protection circuit. Based on the TP4056 charger IC and DW01 battery protection IC this module will offer 1A charge current then cut off when finished.
Furthermore, when the battery voltage drops below 2.4V the protection IC will switch the load off to protect the cell from running at too low of a voltage and also protects against over-voltage and reverse polarity connection (it will usually destroy itself instead of the battery) however please check you have it connected correctly the first time.
Led indicator: RED is charging GREEN is fully charged.
-
- Ampere meter can only be connected to a 5v input end of the module.
- It is better than the charging current is 37% of the battery capacity. If you charge the battery of 1000mAh, acurrent of 400mAh is enough.
- The connection wire should not be too thick.
- Make sure the connect point is good.
- If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-subtract the charging current to avoid burn damage to the chip.
- NO Reverse polarity.
Working Functions:
-
- Connect micro USB cable for power, or 5V DC to pads marked IN+ and IN- on the left-hand side of the module
- Connect cell to charge to B+/B- pads on the right-hand side of the module.
- A load (something for the battery to power) can be connected to the OUT+/OUT- pads on the right-hand side
- Important! Disconnect load when charging
- The red LED indicates charging in progress, green LED indicates charging has finished.
- Never charge your battery at a rate greater than 1C
Package Includes:
-
- 1 x TP4056 1A Li-Ion Battery Charging Module Micro USB with Current Protection
Additional information
| Weight | 1.5 g |
|---|---|
| Dimensions | 2.7 × 1.7 × 5 mm |
Reviews
There are no reviews yet.