Roll over image to zoom in
COLLISION SENSOR 3D PRINTER LIMIT SWITCH
₹35.00
You save
Collision sensor, also known as electronic switch, is a digital on-off input module necessary for elementary electronic learning. By programming, it can realize control over light, sound device, key choice function of LCD display etc. Using 3P sensor cable to connect it to sensor shield, it can be installed to 4WD AL alloy mobile robot platform to realize collision detection function. It is both convenient and effecient.
-
- Voltage: 3.3 – 5V
- Output port: digital level signal
- Probe: microswitch
- Compatible with sensor expansion board
- Quick response and without delay
- Out: ( touch ) high level / ( release ) low level.
- Module with mounting hole for convenient use
- Application: Arduino, single chip, ARM and Raspberry Pi
Wiring / Connection:
-
- VCC: 3v-12v power supply
- GND: then the power ground
- OUT: high and low output
Package Includes:
-
- 1 x Impact Switch Collision Switch Sensor Module for Arduino
Additional information
| Weight | 5 g |
|---|---|
| Dimensions | 25 × 20 × 5 mm |
Warranty
- This item is protected with a supplier warranty of 5 days from the time of delivery against manufacturing defects only.
- Reimbursement or Replacement will be done against manufacturing defects only.
- This warranty is void if the device has been damaged by negligence, mishandling, acts of third parties, accident, fire, Flood, lightning, power surges or outages, or other events or circumstances outside the control.
Reviews
There are no reviews yet.